Main Features: - Recessed and sideway pin headers facilitate the connection of wires to the pads - Dedicated boot button makes flashing firmware easy - Reinforced soldering pads for trouble-free soldering - Extremely low center of mass design helps to balance the drone - 7V to 42V input voltage to power the board directly from flight pack up to 6S ( on "BAT" pad only! ) - Merged VIN and VBAT, i.e., it only needs a single wire to power the board in order to have voltage input and telemetry / OSD voltage data - Filtered voltage output - 5V 800mA ( and 3.3V 150mA where applicable ) to power peripherals such as GPS, receiver, black box, OSD - 5V / 3.3V output selection for receivers - Supports CleanFlight ( RACE target ) - Supports BLHeli flashing by hardware - RaceFlight ready, BetaFlight ready
Specifications: STM32F303CCT6 ( 256kB flash ) 32-bit processor MPU6050 gyroscope / accelerometer High-quality, gold-plated PCB Micro USB connector for programming Mounting holes: 30.5mm square to center of holes
Flight Controller Type
Dimension and Weight
Product size (L x W x H)
3.50 x 3.00 x 2.00 cm / 1.38 x 1.18 x 0.79 inches
Package size (L x W x H)
11.00 x 7.50 x 4.50 cm / 4.33 x 2.95 x 1.77 inches
1 x Flight Controller
Product Safety Disclaimer:
We do not accept any responsibility or liability for misuse of this or any other product. All our products are extensively tested to comply with rigorous and strict QC standards. For certain products (e.g. toys, knives, etc.), we recommend proper supervision as we cannot be held liable for misuse or accidents.
Small Parts Disclaimer:
These toys contain small parts, not for children under 3 years in case of swallowing or choking . We do not accept any responsibility or liability for misuse of this or any other product.
If you have any questions about this product, delivery, payment options, etc, please feel free to submit your enquiry. We will reply to you within 24 hours.