Featuring Evolv DNA 75 chip, the Thinkvape Finder 75W has strong functions: temperature protection, preheat, OLED screen, reverse polarity protection, onboard programmable multicolor LED and waterproof onboard buttons. Powered by dual 18650 batteries, it will provide plenty of power and battery life. What is more, it is constructed of zinc alloy and the battery cover is carbon fiber, plus there is even a bit of genuine leather thrown in there too. The Abalone shell on the fire button is a nice touch. Firmware upgrades and customization are also available by connecting to your PC through the micro-USB port.
Thinkvape Finder 75W TC box mod
Equipped with Evolv DNA 75
Reverse polarity protection
Onboard programmable multicolor LED
Output wattage: 1 - 75W
Output voltage: 2.0 - 6.0V
Input voltage: 3.2 - 4.2V
Input current: 0.5 - 25A
Temperature control range: 100 - 300C / 200 - 600F
Zinc alloy, carbon fiber, genuine leather construction
Abalone shell fire button, waterproof
Work with dual 18650 batteries ( not included )
510 manual connection
Micro USB port
Magnetic battery cover
Temperature Protection: the DNA 75 directly measures and limits the temperature of the heating coil during operation. Appropriate temperature settings will also reduce the breakdown of flavoring and base liquid components, which could impact taste or safety. Evolv's Temperature Protection Technology requires a heating coil made from Nickel 200 alloy or other materials with a well-defined temperature coefficient of resistance, rather than Nickel Chromium or Kanthal alloys. If the temperature reaches the maximum value, the wattage applied to the atomizer coil is reduced to prevent overheating.
Preheat: when the DNA 75 is used with a temperature sensing atomizer, an additional feature called preheat is activated. No vapor is produced when the temperature is below the boiling point of the liquid. Preheat applies extra power until the heating coil is up to operating temperature to shorten the delay between pressing the fire button and generating vapor. Because preheat is temperature based, it will not overheat or burn the vapor.
Attaching a New Atomizer: the DNA 75 uses the resistance of the atomizer to calculate the temperature of the heating coil. It continually looks to see whether a new or changed atomizer has been connected. When you connect a new atomizer or disconnect and reconnect your existing atomizer, the DNA 75 will prompt you to confirm this change. When you fire the first time, before activating the DNA 75 will prompt "New Coil? UP YES / DOWN NO". When you see this prompt, if you have attached a new atomizer, press the UP button. If you have disconnected and reconnected the same atomizer, press the DOWN button.
OLED display: watt setting, battery indicator, temperature display, volts display, ohms display
Modes: locked mode, stealth mode, power locked mode, resistance lock, max temperature adjust
1. If you are using temperature protection, be careful to only attach new atomizers that have cooled to room temperature. If a new atomizer is attached to the DNA 75 before it has cooled down, the temperature may read and protect incorrectly until the new atomizer cools.
2. The temperature reading is the average temperature of the atomizer coil, and care should be taken to construct the heating coil so that the temperature is uniform, without hot or cold spots.
|Dimension and Weight||