Servo Sync ( feature does not work with module systems )
Preset failsafe system.
Red LED indicates number of hold
Brand Name: REDCON
Item Name: CM621 receiver
Dimensions ( W x L x H ): 18.5 x 40 x 10mm
Voltage Range: 4 - 10v
Brown-Out Voltage: 4.0v ( always supply power above this voltage )
Antenna Length Main RX: 30mm
Expected Range: 300m ( tested with Spektrum DX4E )
Compatibility ( Spektrum and JR DSM2 ): DSX7, DSX9, DSX11, DX18
Note: This receiver may not compatible with EU market spektrum transmitters ( which doesn't support DSM2 ).
1. Put the binding harness into connector location marked BIND. Next apply power to the receiver. Receiver LED should illuminate it means bind is accomplished
2. To set fail-safe throttle and control surface positions, ( minimum throttle and all control surfaces set to neutral is suggested ). Press and hold the bind button of transmitter ( LED will illuminate ), turn on the transmitter.
3. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. All fail-safes should be programed correctly now.
4. Remove binding harness from the BIND channel. Restart the receiver by cycling it power off and turn on and connect battery into BIND channel is recommended. All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. Surfaces and throttle should return to your preset fail-safe positions.
|Dimension and Weight||
We do not accept any responsibility or liability for misuse of this or any other product. All our products are extensively tested to comply with rigorous and strict QC standards. For certain products (e.g. toys, knives, etc.), we recommend proper supervision as we cannot be held liable for misuse or accidents.